Rebar Bending Machine – Durable, Accurate & Easy to Operate

A Rebar Bending Machine is the heartbeat of fast, safe steel bar shaping. At Topall, we build ours for Indian job sites where reliability matters more than buzzwords. Plug it in, set the angle, and watch the machine turn stubborn TMT rods into perfectly bent reinforcement—no sweat, no delays.

What Sets Topall Apart

Topall’s Rebar Bending Machine pairs a heavy, duty copper & wound motor with a calibrated gearbox, so each bend lands exactly where you dial it. An ergonomic handle and clear angle scale mean even new operators feel confident in minutes. Inside, sealed bearings cut maintenance downtime while an overload cut?off guards the motor against voltage spikes common on rural grids.

How It Works Day to Day

Feed any 6mm–40mm bar into the slot, choose your angle on the selector knob, and tap the foot switch. The table rotates smoothly to 0-180°, delivering repeatable results shift after shift. Because the bender sits on vibration damped feet, it stays put even on uneven concrete, protecting both machine and crew.

Big Benefits on Busy Projects

• Productivity boost – one operator bends hundreds of bars per hour, freeing others for tying and placement.
  

• Cost control – precise angles slash bar wastage and rework.
  

• Site safety – hands stay clear of moving parts thanks to shielded rollers and emergency stop.
  

• Portability – fork lift slots and compact dimensions let you hoist the unit floor to floor.
  
  

Practical Uses Everywhere Steel Meets Concrete

Bridge decks, metro piers, precast yards, high rise columns—wherever reinforced concrete goes up, contractors trust our Rebar Bending Machine to keep schedules tight. 

Why Contractors Choose Topall

We design, fabricate, and test every unit in house, then back it with a nationwide service network. Spare parts ship within 24 hours, and on site training is free. That commitment keeps Topall brands working long after generic imports stall.

Quick Recap

If you need a rugged, accurate, and easy to run Rebar Bending Machine, choose Topall. Fewer breakdowns, faster bends—that’s productivity you can measure in saved days and stronger margins.

Frequently Asked Questions

Q1. How many bends per hour can the machine handle?
 A well?trained operator typically bends 300–400 standard 12 mm bars in one hour.

Q2. Does it work with ribbed TMT steel?
Yes; hardened rollers grip ribbed or plain bars equally well.

Q3. What power supply is required?
 A standard 415 V, three phase line runs the 3–5 HP motor efficiently.

Q4. Can I bend bars beyond 180 degrees?
 The built in stop plate limits rotation to protect the gearbox; compound bends are done in two passes.

Q5. How often should I service the machine?
 Routine greasing every 200 hours and an annual gearbox oil change keep it in top form.

Q6. Do you provide spare parts?
Absolutely—Topall stocks all critical spares locally for quick dispatch.